I kill your pain - 1:1 CBD GrowerStuffer

Hello everyone! I have never grown on coconut and hydroponics before, used only substrates with soil, and now I am starting my first grow on coconut with reversible watering. Maybe I will need your advice and recommendations. Please be happy in my first report on the growdiaries. I started by tossing a Painkiller seed into a Root Riots. Then I prepared a starting solution for buffering the substrate, poured it into the WaterFarm system (T.A) and turned it on for several hours. Here and throughout the report I will indicate not milliliters, but ppm solution. Now I will tell you about my setup, what kind of light and hydroponics I use. In the following I will describe the fertilizers used, as well as the rotary variety. 🙌 For the plant, I use a reversible irrigation system Euro WaterFarm V3 GHE 😎 Its characteristics: Air pump capacity: 78 l / h Water pump power: 1.8W Air pressure: 0.012 MPa Size (length-width-height): 30x30x37 cm Tank volume: 15L (solution volume 8L) Characteristics of my main lamp😇 Name: SIYANIE QuasarBoard 100 Elite v2 UV: Power consumption: 105W Efficiency: 2.95 mmol joule Number of white diodes Samsung lm301b: 160pcs Number of red diodes Samsung lh351h v2: 20pcs Number of Seoul UV diodes: 385nm - 2pcs, 395nm - 2pcs, 405nm - 1pc Driver: MeanWell ELG-100-36 Board temperature 48C One panel is designed for a box area of up to 0.36 m2. Panel size: 407 * 307mm Characteristics of my additional lighting, which I will turn on later😈 SIYANIE Red 660nm Booster 30 Watt: 2 strips 40 * 7cm 15W each, driver 30W Each bar has 12pcs diodes Samsung lh351h v2 MeanWell driver. Planks: 29volt, 500mA. The current per diode is 500mA. For what and where: This additional light is needed to enhance flowering and active mass gain of inflorescences.